Day: December 5, 2018

Do-it-yourself construction of interior partitions

  Do-it-yourself construction of interior partitions

Step 5: cross-shaped fastening of profiles between themselves for the construction of the opening

  • on the back of the racks and the crossbar, we will prepare small holes for the nail. To do this, you need a drill with an appropriate drill. Bars are drilled to a depth of 50 mm, which will be almost half of the nail;
  • nails 120-150 mm, you need to fasten wooden structures that are inserted into the profiles. To do this, hammer nails very carefully with an ordinary hammer;
  • we finish the mounting of the crossmember after screwing in the screws on the side on both sides.

Profile types for drywall: size and price

What determines the quality and durability of interior decoration. Characteristics of metal profiles.

Having fully built the doorway, we begin to install the remaining vertical pillars. (more…)

Construction of a country house with their own hands

Vertical rack mount options

Connection by corners is less rigid, therefore it is desirable to use it only in small houses. If the structure is large enough, then these 2 ways can be combined.

To ensure that the racks do not tilt during the assembly process (as long as they are fixed only in the lower part), they are additionally fixed with temporary braces in the form of ordinary slats. Permanent braces are installed only after the work with the top trim is completed.

  Construction of a country house with their own hands

Strengthening stands with temporary braces

Note!
In the bars of the upper trim, the holes must be exactly above the holes in the lower trim.
Offset, even a couple of centimeters will cause the curvature of the struts of the frame.

In the process of assembling the frame you need not to forget about the window and door openings. (more…)

Cheapest home foundation

The construction of this type of foundation is as follows: according to the project, trenches are digged to the calculated depth (usually 0.7 m). The thickness of the anti-cushion cushion is -0.3 m. Its lower part (0.2 m) is made of coarse sand, the upper part (0.1 m) is made of a mixture of sand and rubble.

Each layer is carefully rammed. Then a plastic film is laid on the base so that the cement milk from concrete does not go into the sand pillow. At installation of boards of a timbering panels of roofing material fasten to them. Their purpose is to prevent the cement milk from flowing out of the fresh concrete mix through the gaps between the boards, to facilitate the dismantling of the formwork, and also to save the lumber for further use. Then the reinforcement cage is knitted and concrete is fed into the trenches. (more…)

Doing the foundation with your own hands

5. Installation of valves. It is better not to weld the armature, but to bind with the help of a wire, since there will be weak spots in the places of welding. It can be knitted by hand or with the help of a special pistol that is tucked in with a wire bay. For tightening more convenient to use a special hook.

  Doing the foundation with your own hands

Crochet pattern

6. Pouring concrete. Alignment To achieve a monolithic ribbon of concrete, the solution must be poured as thoroughly as possible. With large volumes, you can use the finished solution.

For work using concrete M200-M400. When using the M200 grade, the quality of the sand (its class) should be higher. The proportions of the solution can be calculated using the table below.

Filling is done in layers no more than 20 cm. After the trench is filled with concrete, it is trimmed with a bayonet spade or by tapping on the frame of the reinforcement or formwork. (more…)

How to lay laminate on uneven wooden floor

After leveling the floor and cleaning it from debris, a springy damping tape is laid to damp sounds along the walls. So that the seams of the substrate do not fall on the joints of the boards, sheets or roll substrate roll out across the floor across the direction of the laminate lamellas.

It fits only the smooth side up and is interconnected end to end, without overlap. To avoid shearing the substrate, all sheets are fastened together with building tape. If the damper tape is not used, you can put the edges of the substrate a little to the wall a couple of centimeters. In the future, the excess is cut off. In order not to crush the porous material while walking, it is not recommended to lay the entire substrate at once – it is better to lay it out as needed.

Laying laminate step by step

(more…)

How to build a shield house with your own hands

Before starting construction work, you need to decide what type of construction you want to build. The most common version of the houses built with their own hands – frame-shield. You can build a shield house from a variety of materials. For the frame can be used timber or board. It is very important to distribute the load on the basis of the structure.

  How to build a shield house with your own hands

The layout of the panel house.

Such structures are characterized, above all, durability and strength. The construction of the panel house means the creation of safe for health and comfortable living conditions, therefore, in many respects, houses of a frame-shield type are superior to structures made of concrete, stone or timber. Optimal temperature and humidity inside the room are created thanks to the vapor and heat insulation layers between the inner and outer layers of the walls. (more…)

Draft floor in the frame house

  Draft floor in the frame house

20 photos of cats made at the right time Cats are amazing creatures, and everyone knows about this. And they are incredibly photogenic and always know how to be at the right time in the rules.

10 charming star children, who today look very differently Time flies, and one day, little celebrities become adult personalities who are no longer recognizable. Cute boys and girls turn into a.

12 things you should not buy in second-hand Check out the list of things that should always be new, and never buy them in second-hand.

What is it like to be a virgin at 30? What is interesting, women who have not had sex almost until reaching middle age.

It turns out that sometimes even the loudest fame ends in failure, as is the case with these celebrities.

Floor frame house with his own hands. Device and step by step instructions

Poles and floor joists

Beams – the main elements of the support, which are laid logs. (more…)