Day: November 1, 2018

Build a change house with your own hands step by step instructions

  Build a change house with your own hands step by step instructions

In addition, the ceiling and floor are made in two layers. Thanks to these techniques, inside the house is warm and dry. And appearance will give facing under a bar. Frame houses can be operated for several seasons, which favorably distinguishes them in comparison with shield panel houses and is an undoubted advantage.

Their only drawback is that the interior is small enough. but this does not interfere with fully exploiting the shed as a summer kitchen, storage of working clothes and tools.

On the video frame house barn, built by hand, – making the base:

Manufacturing and installation of frame walls:

Cabins from logs and logs

This type of construction is distinguished by its high cost, because for its construction bars and logs with a section of more than 100×150 cm are used.

It is recommended to build such sheds only if it is planned to use it as a bath in the future. (more…)

Belt pile foundation technology

It is possible to fill in piles at once, having left the armature which is turned out outside for a sheaf with a tape grid, or simultaneously with MZLF at the following stage. In the second case, the strength will be higher, the service life is longer.

Formwork installation

To reduce the amount of work 70% of individual developers pour the tape into the ground, adding formwork only in the basement above the ground level. In this case, there is no access to the side walls of the foundation for their waterproofing. The correct technology involves the installation of formwork over the entire height of the tape on both sides. This increases the volume of earthworks, the consumption of sawn timber for formwork panels, but it pays off with a high operational foundation resource.

Before installing the formwork, you must perform the following steps:

(more…)

Construction of the hip roof step by step instruction

  Construction of the hip roof step by step instruction

Step rafters hip roof

When designing a hip roof, the step of rafters should be from 60 cm to 1 m. This is done, as a rule, not only for reasons of structural strength. This step is chosen in accordance with the insulation, which will later fit between the rafters, and the standard insulation width is approximately equal to 60 centimeters. Accurate adjustment of the rafters pitch for future finishing materials allows you to save money by eliminating unnecessary trimming and trimming.

Batten hip roof

Device batting gambrel roof. The crate of the hip roof is calculated based on the existing roofing. For each type of roofing material, lathing is calculated individually. The device of the roof lathing and its dependence on various roofing materials were discussed in detail in the article How to make a dual-slope roof with your own hands. (more…)